HPE Community
BladeSystem - General
1753922 Members
7652 Online
108810 Solutions
New Discussion

Connection Virtual Connect Between Switch Brocade, WWN does not appear.

 
Lincoln CWB
New Member

‎08-20-2009 01:09 PM

‎08-20-2009 01:09 PM

Connection Virtual Connect Between Switch Brocade, WWN does not appear.

I have the following problem
Perform the installation of a blade in BL460 Enclosure C7000. The blade has a QLogic HBA Dual.
I made the connection of two Virtual Connects with two Brocade Core Switch.
At the time of creating the zoning in only one of the WWN Switch Brocade appears.
What is the problem?
0 Kudos
Reply
1 REPLY 1
JKytsi
Honored Contributor

‎08-20-2009 11:52 PM

‎08-20-2009 11:52 PM

Re: Connection Virtual Connect Between Switch Brocade, WWN does not appear.

You have two separete fabrics, right ?
You have created two separate fabrics to VC?
You have link up for VC-core switch connections?
You have NPIV capable core switches?
You have assigned VC profiles to servers?

If all yes
then
Go to Qlogic bios and scan for targets there for both fabrics. Usually the core switch port goes to NPIV mode and you can see the connected hosts with portshow command.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.