HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Community
BladeSystem - General
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Deploy ESX on C-Class Blades

 
HansenJ
HansenJ
Occasional Visitor

‎07-07-2009 03:36 PM

‎07-07-2009 03:36 PM

Deploy ESX on C-Class Blades

HP BL465C in HP3000 chassis using RDP to deploy ESX 3.5 U3 RDP server is also DHCP server linux is the Pre-boot O/S. Blade gets DHCP address and PXE boots into linux pre-boot. but is unable to communicate on network after linux loads, i suspect broadcom driver in RDP frm is at issue but would like to know if this is the best place to start
0 Kudos
Reply
2 REPLIES
Sobhan Majumder
Sobhan Majumder
Occasional Advisor

‎07-07-2009 11:09 PM

‎07-07-2009 11:09 PM

Re: Deploy ESX on C-Class Blades

Which version of RDP you are using?
Download latest RDP. Latest ver is 3.83. Probably your problem will be resolved.
0 Kudos
Reply
HansenJ
HansenJ
Occasional Visitor

‎07-08-2009 06:08 AM

‎07-08-2009 06:08 AM

Re: Deploy ESX on C-Class Blades

Thanks,
I am trying to avoid 3.5 GB iso download and upgrade. I am looking for verification that downloading updated frm files (250MB) from HP/Altiris would address the problem quickly and without breaking any of the other components which are currently performing flawlessly
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.