BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Enable Disk Write Cache on Smart Array P410i

SOLVED
Go to solution
tima75
Occasional Contributor

Enable Disk Write Cache on Smart Array P410i

I have a question for Smart Array P410i .

I built Raid 1 array on P410i.

and I'd like to enable "Disk Write Cache" on this Array Controller.

 

hpacucli ctrl slot=0 show

Smart Array P410i in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0
Serial Number: 5001438010A99C60
Cache Serial Number: PBCDH0CRH0S7KL
RAID 6 (ADG) Status: Disabled
Controller Status: OK
Hardware Revision: Rev C
Firmware Version: 5.14
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 3 secs
Surface Scan Mode: Idle
Queue Depth: Automatic
Monitor and Performance Delay: 60 min
Elevator Sort: Enabled
Degraded Performance Optimization: Disabled
Inconsistency Repair Policy: Disabled
Wait for Cache Room: Disabled
Surface Analysis Inconsistency Notification: Disabled
Post Prompt Timeout: 15 secs
Cache Board Present: True
Cache Status: OK
Accelerator Ratio: 25% Read / 75% Write
Drive Write Cache: Enabled
Total Cache Size: 512 MB
No-Battery Write Cache: Disabled
Cache Backup Power Source: Capacitors
Battery/Capacitor Count: 1
Battery/Capacitor Status: OK
SATA NCQ Supported: True

 

> Drive Write Cache: Enabled

Drive Write Cache seems to be enabled...

 

>Cache Backup Power Source: Capacitors

But this controller is without battery?

 

>No-Battery Write Cache: Disabled

so Do I have to Enable "No-Battery Write Cache"?

 

or is "Drive Write Cache" already enabled?

 

1 REPLY
PGTRI
Honored Contributor
Solution

Re: Enable Disk Write Cache on Smart Array P410i

hi,

 

The controller has a battery/capacitor

 

"Battery/Capacitor Count: 1"

 

and the write cache is already enabled.

 

Everything seems to be fine.

 

Thanks

 

regards,

 

How to Say Thank You? Just click the KUDOS!