BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Enclosure C7700 interconnect bay configuration

AndreV
Occasional Contributor

Enclosure C7700 interconnect bay configuration

We have a blade enclosure which has a fabric switch cisco mds 9124e in bays 3 and 4 which have the incorrect management IP/URL info in OA and need to know how I can configure the management IP address/URL for this interconnect bay. 

I am totally new to enclosure management.

Andre

1 REPLY
Torsten.
Acclaimed Contributor

Re: Enclosure C7000 interconnect bay configuration

In OA go to EBIPA and check the IP address settings. If the modules uses fixed addresses for any reason, try a serial connection to the modules.

 

Open a ssh to OA, then do

connect interconnet 3

for bay 3 and so on ...


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!