BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Error with failover at the windows 2003 with MSCS services

Douglas Fernandes
Occasional Visitor

Error with failover at the windows 2003 with MSCS services

Hello,

I have a blade system with the following configuration;

1 – Enclosure C7000
2 – BL 465 G1 attached with mezzanine card NC364m Quad Port
2 - GbE2c Ethernet Blade Switch attached at the Bay 1 and 2
1 – GbE2c Ethernet Blade Switch attached at the Bay 5
1 - HP 1Gb Ethernet Pass-Thru Module attached at the bay 6
1 – MSA 2000 ISCSI

The SO has windows 2003 with the MSCS service installed.

The NIC card are configuration:

Switch 1 Bay 3 ISCSI - 10.x.x.x
Switch 2 Bay 4 ISCSI - 20.x.x.x
These IP are the same sub at the MSA 2000

Switch 3 Bay 3 and 4 - 192.x.x.x
Pass-trough bay 3 and 4 heart beat - 1.x.x.x.

The problem:

The MSCS start and the applications are moved by the cluster if a made the move group or restart the SO at the active node normally.

When I made a failover test at the SO at the node active, the cluster isn’t moved to other cluster server.

I would like to know the following

1 – Is possible my blade system works with Windows MSCS service?
2 – Where is the error at the implementation?

Regards
1 REPLY
Douglas Fernandes
Occasional Visitor

Re: Error with failover at the windows 2003 with MSCS services

Hello guys,

Nobody has the answer for my questions?

Thanks in advance...