HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

FC firmware of bl460c FC mezz card

 
Rommel T. Misa_2
Frequent Advisor

FC firmware of bl460c FC mezz card

Hi All,

I tried to update the firmware of the FC mezzanine card on a bl460c using the zip file I downloaded from HP. The update fails and gives out the following message:

"The file C:\zf270a5\LP6DUTIL.EXE is valid, but is for a machine type other than the current machine."

The current firmware is at 2.50a8 and I'm trying to upgrade it to 2.70a5. Hope you can help me. Thanks...

Rommel
1 REPLY
Víctor Cespón
Honored Contributor

Re: FC firmware of bl460c FC mezz card

If you check the readme.txt on that file, it says:
LP6DUTIL.EXE DOS-based diagnostic utility 9.3a6
This utility must be run booting in MS-DOS. It's also explained here: http://www-dl.emulex.com/support/hardware/lp8000/fw/df391a3/pdf/fwupdate.pdf

To update firmware from Windows, use HBAnyware utility.
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=329290&prodSeriesId=1844100&prodNameId=1844101&swEnvOID=1005&swLang=8&mode=2&taskId=135&swItem=co-47142-1