BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Fabric login fails for BL490c on Virtual Connect

 
Simon_Geary
Advisor

Fabric login fails for BL490c on Virtual Connect

Hi, I have two C7000s with FC Virtual Connect which are working fine with other blades. I've added a new BL490c in to each chassis and cannot get either blade to log on to the fabric. QLogic QMH2462 is the HBA. VC manager says the HBA is 'NOT-LOGGED-IN' and the Brocade switch doesn't list the VC assigned WWN in the name table. Can anyone help with this, or know how to go about troubleshooting? I've tried the blades in different slots and so far as I can tell the server profile seems correct. Thanks.
2 REPLIES
The Brit
Honored Contributor

Re: Fabric login fails for BL490c on Virtual Connect

Just a thought, check that the SAN Switch ports have NPIV enabled.

Dave.
Simon_Geary
Advisor

Re: Fabric login fails for BL490c on Virtual Connect

This was fixed by upgrading the VC FC firmware to version 1.32.