HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

Factory HBA

 
BobsYourUncle
Occasional Visitor

Factory HBA

Is there a way to obtain the Factory WWNs of blades that have been assigned by VC.

 

We are moving these blades to a Non VirtualConnect chassis and want to pre-stage zoning for that host.

 

 

2 REPLIES
Robert_Jewell
Honored Contributor

Re: Factory HBA

I dont beleive so.  It would seem that unless you remove the FC ports from the VC domain, the firmware on the blades will display the VC given WWNs.

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
Jimmy Vance
HPE Pro

Re: Factory HBA

I don't recall if the WWN is on sticker attached to the Mezz card itself. During POST you can access the settings of the HBA and see the WWN ID

 




__________________________________________________
No support by private messages. Please ask the forum!      I work for HPE

If you feel this was helpful please click the KUDOS! thumb below!