Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Fully loaded C3000 AMP usage

Highlighted
TDH24
Occasional Visitor

Fully loaded C3000 AMP usage

Hello all,

 

We are looking at implementing a C3000 chassis.  Along with the new chassis, we are implementing a Symmetra UPS that has four 30AMP connections and eight 20AMP connections.  We will split the six power cords from the C3000 among two PDUs connected to the Symmetra but I don't know if we should use 20AMP PDUs or the 30AMP?  Can anyone tell me how much amperage the C3000 would use if it was fully loaded? 

 

Thanks in advance!

Troy

1 REPLY
Robert_Jewell
Honored Contributor

Re: Fully loaded C3000 AMP usage

Product Bullitens (Quick Specs) is good for that type of info.

http://h18000.www1.hp.com/products/quickspecs/productbulletin.html#!spectype=worldwide&type=html&docid=12790

 

Look under Power Specs.

 

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!