HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

GBE2C no access to management interface after fw update to 2.0.4

 
AndyEricksen
Occasional Visitor

GBE2C no access to management interface after fw update to 2.0.4

I recently inherited a C3000 blade system with four GBE2C switches.  The switches had old firmware (2.0.0) so it was time to update.

 

Following the instructions I began by updating the first switch to 2.0.4 at which point I no longer had access to the management interface (256).

 

I connected via serial port and configuring interface 256 manually (addr, mask, enable).  I also configured and enabled gateway #1 and #4.  Saved, Applied, Rebooted.

 

I still do not have access to the management interface.  What am I doing wrong here?

 

Thanks for any assistance you can provide.

1 REPLY
AndyEricksen
Occasional Visitor

Resolved: GBE2C no access to management interface after fw update to 2.0.4

seems that I needed to also update the OA firmware.  issue resolved.