HPE Community
BladeSystem - General
1753796 Members
7052 Online
108799 Solutions
New Discussion

Re: GbE2c C-Class Blade Switch port mirroring Issue

 
Bharat_pipl
New Member

‎08-30-2007 11:05 PM

‎08-30-2007 11:05 PM

GbE2c C-Class Blade Switch port mirroring Issue

I have one C7000 blade enclouser and two GbE2c blade Switch,
I have Three BL 480c server with 4-lan port,
I had created a trunk port on 21 and 22, and created three vlans, and i had done a port mirroring on 24, monitor port on server bay 1 at port 9.. but my bandwith is reurning back from trunk ports to my cisco switch..
0 Kudos
Reply
1 REPLY 1
HEM_2
Honored Contributor

‎08-31-2007 02:35 AM

‎08-31-2007 02:35 AM

Re: GbE2c C-Class Blade Switch port mirroring Issue

That shouldn't be happening.

can you verify your port mirroring configuration? The monitor port is the one that you would connect your analyzer (sniffer) to. Your config should look like this:

/c/pmirr/mirror ena
/c/pmirr/monport 24
add 9 both

Are you at fw 2.0?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.