HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

GbE2c C-Class Blade Switch port mirroring Issue

 
Bharat_pipl
Occasional Visitor

GbE2c C-Class Blade Switch port mirroring Issue

I have one C7000 blade enclouser and two GbE2c blade Switch,
I have Three BL 480c server with 4-lan port,
I had created a trunk port on 21 and 22, and created three vlans, and i had done a port mirroring on 24, monitor port on server bay 1 at port 9.. but my bandwith is reurning back from trunk ports to my cisco switch..
1 REPLY
HEM_2
Honored Contributor

Re: GbE2c C-Class Blade Switch port mirroring Issue

That shouldn't be happening.

can you verify your port mirroring configuration? The monitor port is the one that you would connect your analyzer (sniffer) to. Your config should look like this:

/c/pmirr/mirror ena
/c/pmirr/monport 24
add 9 both

Are you at fw 2.0?