HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

GbE2c Ethernet Blade Switch - cannot enable a port when moving a server to another slot

 
Christophe Kottelat
Occasional Contributor

GbE2c Ethernet Blade Switch - cannot enable a port when moving a server to another slot

Hello,
I have an enclosure c7000 with several Blade servers. I would like to move a server from slot 5 to slot 15. When I setup the port 15 on the bay 1and 2 switches (ethernet), I got error "Server Port 15 cannot be enabled because of a mismatch". I checked and this port was never used and is not part of the trunk groups. I tried from the web interface and also from the command line with the same failure. Firmware version is 2.0.50. If I do the same with port 7 (also free) on bay 1 and 2...it works. Please help me to understand that.

Regards
Christophe