HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

GbE2c configure uplink port

 
Vikkte
Occasional Visitor

GbE2c configure uplink port

Hi everyone,

 

I need separate uplink traffic to different uplink port

like this

traffic from port 1-8 go to uplink port 20

traffic from port 9-16 go to uplink port 21

 

Any ideas?

1 REPLY
Matti_Kurkela
Honored Contributor

Re: GbE2c configure uplink port

Pick two unused VLAN numbers. For example, 101 and 102. Assign descriptive names for them, and enable them.

 

Configure ports 1-8 and uplink port 20 to VLAN 101 only.

Configure ports 9-16 and uplink port 21 to VLAN 102 only.

Make sure VLAN tagging is turned OFF for all these ports.

 

As all the ports are in untagged mode, the switch module won't accept nor emit VLAN tags. So everything will work just as before... except that ports 1..8+20 are now separated from ports 9..16+21.

MK