BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

HOW TO CONVERT SD2 220V TO 380V? - WARNING!

 
chuckk281
Trusted Contributor

HOW TO CONVERT SD2 220V TO 380V? - WARNING!

Solamara was looking for power configurations:

 

**************

 

We have a customer wich have a SuperDome2-16S and he needs to convert SD2 from 220V to 380V.  Do you have any information about what is necessary to do this convertion?

 

**************

 

Input from Dennis:

 

**************

 

I am not sure about the power specifications in Brazil, but typically this is achieved via the “Doublemint” 3-phase inlet to single phase outlet PDU in the UK.

This is Option #005 for UK 3phase 5wire and uses the AF518A 32A PDU, which is really good, just think about where it would fit in the rack (0U or 1U).

The SD2 Power option matrix is in the SD2 quickspec, but it is unreadable, so here it is enclosed.

You could also swap out the IPM, but I would recommend using PDU’s as it does not impact the SD2 directly and swapping out the IPM is not as straightforward as you might think.

 

webpic188.jpg

 

webpic189.jpg

 

webpic190.jpg

 

***************

 

Scot also chimed in:

 

*****************

 

Dennis has correctly described the equipment set to make this change.  IT IS IMPERITIVE THAT NEW PDUs (if PDUs are being used) WITH THE 5 WIRE CONFIGURATION BE USED.

 

******************

 

Other comments or questions?