HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

HP 1Gb Ethernet Pass-Thru Module for c-Class BladeSystem

 
phillj_1
Occasional Advisor

HP 1Gb Ethernet Pass-Thru Module for c-Class BladeSystem

Hi,

I am new to the c class system & was wondering about the setup of the pass tru module (subject).
It mentions that they are redundant, how? I have a network engineer telling me that we should a primary and secondary nic. Are all the poerts not used?

I have 4 pass thru modules installed & i understand the port mapping but unsure if any of the ports are secondary & not in use.

I have plugged in one blade & caonnected 8 cables (correct ports) as mentioned above the network engineer says i need to inform him which are primary and which are secondary. I have checked the Onboard HP website & cant find any information.

Any help much appreciated.

Thanks
1 REPLY
Cederberg
Honored Contributor

Re: HP 1Gb Ethernet Pass-Thru Module for c-Class BladeSystem

Hi philli.

Both Nics that go out of a pair of Eth. passthoughs is active. In this case redandant means that you have two and one nic in each which means that even if one is broken you still have a path to your network.

A way to make them more redundant is to team the network cards on the server.

All ports that matches the portmapping is in use. You can see it on the OA card Devicebays --> Baynumber/servernamn --> portmappping.

Depending on how you have setup your bladesystem various ports can be sent out into thin air. I'm attatching a powerpoint so you can see how the diffrent mezzcards mapp against the backplane.