HPE Community
BladeSystem - General
1751734 Members
5411 Online
108781 Solutions
New Discussion

Re: HP BL35p SAS Controller

 
Mark Caballero
New Member

‎12-11-2009 08:26 AM

‎12-11-2009 08:26 AM

HP BL35p SAS Controller

Good Day.

After replacing the SAS controller of BL35p server, are there any configurations to be made? Software or hardware side to that extent?

Could it be swap from the same unit with the same part number without any problem (configuration), just like plug n play?

Thanks.
0 Kudos
Reply
1 REPLY 1
Sameer_Nirmal
Honored Contributor

‎12-11-2009 11:35 AM

‎12-11-2009 11:35 AM

Re: HP BL35p SAS Controller

IIRC after replacing the SAS controller, you need to use LSI configuration utility when the server is powered on and "add the SAS drives there. Once added, the controller reads the logical drive configuration off the drives and makes available to use.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.