HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

HP BL35p SAS Controller

 
Mark Caballero
Occasional Visitor

HP BL35p SAS Controller

Good Day.

After replacing the SAS controller of BL35p server, are there any configurations to be made? Software or hardware side to that extent?

Could it be swap from the same unit with the same part number without any problem (configuration), just like plug n play?

Thanks.
1 REPLY
Sameer_Nirmal
Honored Contributor

Re: HP BL35p SAS Controller

IIRC after replacing the SAS controller, you need to use LSI configuration utility when the server is powered on and "add the SAS drives there. Once added, the controller reads the logical drive configuration off the drives and makes available to use.