HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Blade CClass7000 Virtual connect module

 
CowBoy
Regular Advisor

HP Blade CClass7000 Virtual connect module

Dear All
I have Blade c7000 with HP switch(Virtual connect module).
The problem is that we can not config VCM(virtual connect module[VC-ENET 1/10G]) because VC-MODE is disabled so in ILO Onboard administration has not Virtual connect manager optin .
Is There any license to enable that mode or something else ?????
I want to create VLAN on The Switch?????
3 REPLIES
Niels Vejrup Pedersen
Respected Contributor

Re: HP Blade CClass7000 Virtual connect module

Hello,

Are you missing the link to the Virtual Connect Manager, or ?

Please check that you have firmware (OA, BIOS, ILO, VC) in a supported mix.

http://h18004.www1.hp.com/products/blades/components/c-class.html#tab3_content

Check the Compatibility tab.

Regards,
Kritao
Regular Advisor

Re: HP Blade CClass7000 Virtual connect module

Hi,

It could be firmware issue only. Since you are not getting the access to configure Virtual connect Manager, you will not be able to update the firmware. So please download VC firmware update command line utility along with the latest VC firmware to update the Firmwares.
JKytsi
Honored Contributor

Re: HP Blade CClass7000 Virtual connect module

Have You set the enclosure bay IP addressing ?? Without management IP the VC module is quite hard to manage....
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi