HPE Community
BladeSystem - General
1752577 Members
5328 Online
108788 Solutions
New Discussion юеВ

HP Blade Enclosure Power

 
flex10
Occasional Contributor

тАО02-02-2010 05:29 AM

тАО02-02-2010 05:29 AM

HP Blade Enclosure Power

Dear Forum

Could you please advice on the power supplies on a c 7000 enclosure

We have a 16 Circuit braker, if we connect a 16 PDU and give power to each power supply, will cause any problem? please advice
0 Kudos
Reply
2 REPLIES 2
JKytsi
Honored Contributor

тАО02-02-2010 09:04 AM

тАО02-02-2010 09:04 AM

Re: HP Blade Enclosure Power

please use bladesystem sizer tool to calculate requirements to your configuration.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
JonathanT
Frequent Advisor

тАО02-02-2010 09:56 PM

тАО02-02-2010 09:56 PM

Re: HP Blade Enclosure Power

In our lab we ran two 20 amp 110V circuits to the C7000 for basic testing which worked fine. In production we provide two 30amp 208V circuits to the C7000. You really need to use the sizing tool and look at the amps, voltage, and redundancy that you're trying achieve.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.