HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

HP C7000 with Flex-10 can't get to work with ESX, 2003 or 2008

 
CTgeek
Occasional Advisor

HP C7000 with Flex-10 can't get to work with ESX, 2003 or 2008

We have a C7000 that is connected to a CISCO switch. The cisco switch configuration is as follows:
!
interface range GigabitEthernet1/0/39 - 46
description *** Trunk to HP C7000 Enclosure Side B ***
switchport trunk encapsulation dot1q
switchport trunk native vlan 301
switchport trunk allowed vlan 170,204,301
switchport mode trunk
channel-group 3 mode passive
!

We have the C7000 setup (see attached) but we can't the machine to do DHCP. I have also tried changing the nic to a static address but it does not get out. I have already disabled the firewall on the machine. Any ideas as this is holding up our project... Thanks!
2 REPLIES
CTgeek
Occasional Advisor

Re: HP C7000 with Flex-10 can't get to work with ESX, 2003 or 2008

Ignore the ESX pics as I choose the wrong ones and am having the same issue with it. I am sure it is a C7000 setup issue for both. If you need pics from 2003, 2008 or the esx I can provide them. Thanks
CTgeek
Occasional Advisor

Re: HP C7000 with Flex-10 can't get to work with ESX, 2003 or 2008

This is awful. A forum where questions don't get answered. I'm closing this and will be pay for support elsewhere...