BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

HP ProLiant C class

PigPig
Occasional Contributor

HP ProLiant C class

Just setup the blade server and was wondering, how to change the bios name of the server or rather the switch name as I can’t since to find the path to change it.
3 REPLIES
Ricknsa
Frequent Advisor

Re: HP ProLiant C class

Are you using Virtual Connect? Are you using the 3000 or 7000 chassis? Have you setup the Onboard Admin?
Ricknsa
Frequent Advisor

Re: HP ProLiant C class

Try this,

Enter the ILO directly, or through the OA, preferably through the OA.
On the system status page, Click on the "Server Name" Change the ILO server name there.

Next click the "Administration" Tab, and under settings on the left hand side select Network. Here you can change the name of ILO Sub interface or host name.

Keep in mind this for the server ILOs. For the Enclosure, you will need to access the â On Board Adminâ , once there; all of the enclosure settings are on the left hand menu under "Enclosure Settings" and "Active Onboard Administrator"

If you are trying to name or configure one of the switch modules, you should be able to enter the module management pages or Virtual Connect, through the â On Board Adminâ

Can you access the OA "On Board Administrator" ?
PigPig
Occasional Contributor

Re: HP ProLiant C class

Thanks I go try.