BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

HP VC 8GB port mapping

 
stephen baugh
Occasional Visitor

HP VC 8GB port mapping

Hi,

Apologies in advance if this is a dumb question but new to the HP blade's. Ive got a C7000 with 2 flex 10 and 2 8GB fibre modules installed, I can see the port mappings on the flex 10 module and im able to connect to the blade servers over tcp/ip. My problem is that the port mapping for the FC module is blank, Could anyone let me know what im doing wrong, the VC firware is 2.30.

Any help would be greatly appreciated
4 REPLIES
Markus M.
Trusted Contributor

Re: HP VC 8GB port mapping


Hi Stephen,

First off all: verify your FC interconnects are in Bay 3 and 4, and the blade server have their FC mezz. on port 1.

Please also provide a pic of a blade port mapping.

kind regards
Markus
stephen baugh
Occasional Visitor

Re: HP VC 8GB port mapping

Hi,

Looks like its presented to mezz2

Thanks for your help.

Cheers,
Stephen
WFHC-WI
Honored Contributor

Re: HP VC 8GB port mapping

hi Stephen,

You can either move your HBAs to mezz 1 or move your VC-FCs to bays 5 and 6. The mezzanines and interconnects are hard-coded through the enclosure midplane. Check the Mezzanines section here for more info:
http://h18004.www1.hp.com/products/quickspecs/13421_na/13421_na.HTML#Supported Products


If you are using HP-assigned WWNs they will change upon moving hardware.

good luck, points are appreciated if the answers help!
stephen baugh
Occasional Visitor

Re: HP VC 8GB port mapping

attached is picture of the portmap