BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

How to configure Blade enclosure (BL20P G2) management port?

webboy105
Occasional Advisor

How to configure Blade enclosure (BL20P G2) management port?

I would like to configure the management port of blade enclosure but not sure about the defualt IP address and password. I'm also looking for any documentation which will help to do the job.

help is always appreciate. thanks in advance.
4 REPLIES
Rob Leadbeater
Honored Contributor

Re: How to configure Blade enclosure (BL20P G2) management port?

Hi,

The management port on a p-class enclosure isn't intended to be connected to. It's used to link the various power and blade enclosures together...

You probably want to refer to the enclosure installation guide here:

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00172260/c00172260.pdf

Hope this helps,

Regards,

Rob
David Claypool
Honored Contributor

Re: How to configure Blade enclosure (BL20P G2) management port?

There are 3 RJ-45 connections on the back of a p-Class Enhanced Enclosure. One is a link to the Enclosure above, and one is to the one below. These are not ethernet ports (it's Inter-Chassis Management Bus [ICMB] signaling, a subset of the IPMI spec).

The third is an ethernet uplink for the iLO ports.
webboy105
Occasional Advisor

Re: How to configure Blade enclosure (BL20P G2) management port?

thanks Rob and David.

appreciate.
webboy105
Occasional Advisor

Re: How to configure Blade enclosure (BL20P G2) management port?

not required anymore, thanks