HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

How to configure Trunking between VC Ethernet Interconnect and CISCO Switch ?

 
Yaboto
Super Advisor

How to configure Trunking between VC Ethernet Interconnect and CISCO Switch ?


I want to configure trunking to enable the blade servers in C7000 enclosure to communicate to the WAN through their VC Ethernet Interconnect module that is uplinked to a CISCO switch.
I have been able to get to the Virtual Connect.

Please what is the next step ?
1 REPLY
The Brit
Honored Contributor

Re: How to configure Trunking between VC Ethernet Interconnect and CISCO Switch ?

1. connect cables between your VC ENet modules and the cisco switch.
2. Create a Shared UplinkSet for each Module that you want to use (See
under "Define" menu) and add the ports which have physical connectivity to Cisco Switch. Do not mix ports from different modules in the same uplink set.
3. create VC vlans (Ethernet Networks) and assign them to the UpLinkSets (see under "Define" menu).
4. create VC profile for each blade, and assign the appropriate VC vlan to the NIC ports.

Hope this gets you started.

Dave.