HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

How to dissable LOMs Flow Control by VC?

 
SOLVED
Go to solution
Nima Gh.
Regular Advisor

How to dissable LOMs Flow Control by VC?

We contacted the Broadcom for disabling flow control of bnx2x LOMs and they told that we must use Virtual Connect for this purpose! How is it possible?
5 REPLIES
WFHC-WI
Honored Contributor
Solution

Re: How to dissable LOMs Flow Control by VC?

hi Nima,

The setting to disable flow control is not configurable in the current firmware revision for Virtual Connect.

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01386629/c01386629.pdf
page 33

However you can disable flow control for individual Proliant servers. Check this guide:
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00846707/c00846707.pdf

hope that helps
Nima Gh.
Regular Advisor

Re: How to dissable LOMs Flow Control by VC?

Thank you very much, but there is no guide for linux. this documents talks about windows driver! how this should be done in Linux?
Michael Leu
Honored Contributor

Re: How to dissable LOMs Flow Control by VC?

Try dropless_fc=1 as a parameter to the bnx2x kernel module.

Found here: http://kerneltrap.org/mailarchive/linux-netdev/2009/8/12/6252653
Nima Gh.
Regular Advisor

Re: How to dissable LOMs Flow Control by VC?

Tried but no effect!
Nima Gh.
Regular Advisor

Re: How to dissable LOMs Flow Control by VC?

The Solution: Upgrade the firmware to 2.33 and use set advanced-networking FlowControl= off