HPE Community
BladeSystem - General
1753320 Members
6307 Online
108792 Solutions
New Discussion

How to reset Blade power on RED LED without replace system board

 
BL460
Occasional Visitor

‎09-17-2015 09:38 AM

‎09-17-2015 09:38 AM

How to reset Blade power on RED LED without replace system board

Hi , all

 I have some Blades G1, G6 , and most have power on with red led blinking, Is anyway could rest it, without replace system board , Thks

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎09-17-2015 10:24 AM

‎09-17-2015 10:24 AM

Re: How to reset Blade power on RED LED without replace system board

It means there is an issue. Connect to ILO and inspect the status of the hardware, check the IML logs.

 

Once the issue is fixed, the red LED will turn off.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
BL460
Occasional Visitor

‎09-17-2015 02:19 PM

‎09-17-2015 02:19 PM

Re: How to reset Blade power on RED LED without replace system board

the system unable to power on, just red led blinking, check the log:

 

Could not determine the IP address of the management processor for the requested blade

 

tried swap out Proc,  reset  SW 6, no luck,

 

Thanks,

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.