HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

How to reset Blade power on RED LED without replace system board

 
BL460
Occasional Visitor

How to reset Blade power on RED LED without replace system board

Hi , all

 I have some Blades G1, G6 , and most have power on with red led blinking, Is anyway could rest it, without replace system board , Thks

2 REPLIES
Torsten.
Acclaimed Contributor

Re: How to reset Blade power on RED LED without replace system board

It means there is an issue. Connect to ILO and inspect the status of the hardware, check the IML logs.

 

Once the issue is fixed, the red LED will turn off.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
BL460
Occasional Visitor

Re: How to reset Blade power on RED LED without replace system board

the system unable to power on, just red led blinking, check the log:

 

Could not determine the IP address of the management processor for the requested blade

 

tried swap out Proc,  reset  SW 6, no luck,

 

Thanks,