HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Community
BladeSystem - General
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Hyper-V and BL460C

 
nextshirl
nextshirl
Occasional Contributor

‎10-08-2008 10:23 AM

‎10-08-2008 10:23 AM

Hyper-V and BL460C

I have problems to configure the network in Hyper-V in my blade servers.

My host server has 4 network cards, one for management and the others to the VMs...

I don't know if I'm doing something wrong with the network configuration... these are the steps I'm following for one of the network interface for VMs...

1.- set an Ip address to the interface, I can ping from other servers without problems.
2.- Create a network in Hyper-V with this interface, I create a external network and select the network interface I've configured before.
3.- Once the network is created I can see the new interface in the host... but I can't ping it anymore ¿¿??
4.- added a new legacy network interface attached to this network... the vm has not connectivity...

Any idea?

thanks a lot.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.