BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

ICE on c class blades

Jeff Gawthorpe
Occasional Advisor

ICE on c class blades

Hi There,
My company has recently purchased a couple of c3000 blade enclosres with full Insight Control Environment. I have no experience with any of this and have just been told to make it work! I'm a bit stuck. Could someone advise me what ICE is exactly (I'm assuming it's an extension of HP SIM) and how I install/configure on the blades & enclosures. I've tried looking for Install guides but cannot find anything that really helps. Thanks in advance.
7 REPLIES
JKytsi
Honored Contributor

Re: ICE on c class blades


To get installation started

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00700892/c00700892.pdf

and the rest of manuals

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual〈=en&cc=us&docIndexId=64179&taskId=101&prodTypeId=18964&prodSeriesId=2512052
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
Jeff Gawthorpe
Occasional Advisor

Re: ICE on c class blades

Thanks Jarkko. I'll have a good read of these.
Jeff Gawthorpe
Occasional Advisor

Re: ICE on c class blades

Solution submitted in forum
JKytsi
Honored Contributor

Re: ICE on c class blades

good thing it helped. But read also the forum userguide. You should assign points to answers that helped YOU.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
Jeff Gawthorpe
Occasional Advisor

Re: ICE on c class blades

Hi Jarkko,
Could you please elaborate on your reply as I don't quite understand what you mean. I assigned points because I had previously struggled to find documentation, your answer was therefore extremely useful to me. I have found these forums very helpful and would not wish to offend anyone or do the wrong thing.

Cheers

Jeff
JKytsi
Honored Contributor

Re: ICE on c class blades

Hello,

Here is a link to "forum etiquette"
http://66.34.90.71/ITRCForumsEtiquette/after.html

Now it's too late, because You closed the issue.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
Jeff Gawthorpe
Occasional Advisor

Re: ICE on c class blades

I'm still non the wiser