BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

ILO2 upgrade from 1.43 to newer version

Ulf Norman
Occasional Contributor

ILO2 upgrade from 1.43 to newer version

I have a BL45 with Static IP Bay Configuration.
ILO adress 10.102.81.146 After upgrade to fw 1.50 or later ILO change ipadress to the the other slot 10.102.81.147 why?
2 REPLIES
Glenn Milne
Occasional Advisor

Re: ILO2 upgrade from 1.43 to newer version

So your saying that you have a static iLo ip address of .146. After an upgrade to 1.50 (or later) the next slot in the Enclosure Ip Addressing is now set to .147? Maybe you have the Autofil turned on so it's assuming that you want the next IP address to go in the next slot. Below is the explanation from the help menu of the enclosure:

Autofill
Assigns consecutive IP addresses for the selected device bays below in the device list. Click the autofill down arrow to assign the IP addresses.


Ulf Norman
Occasional Contributor

Re: ILO2 upgrade from 1.43 to newer version

Yes i have autofill turned on. With the 1.43 fw the 2slot BL45 always give the ilo the "left slots" ipadress, in this case .146
After the upgrade of fw to 1.50 or later the ipadress switched to the "right slots" ipadress .147 This happen to all my bl45.