HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Insufficient enclosure Power Blade chassis C7000

 
upuvvad1
Occasional Visitor

Insufficient enclosure Power Blade chassis C7000

Hi,

I have a c7000 chassis fully populated with bl460g6, and configured the power system to non-redundant and using 3 PSU's in the slots 1,2 and 4 of the chassis as mentioned in the manual.

When I try to power on the blades, few of them were not powered on and displays erros, insufficient enclosure power.

The total enclosure power was approximatley 2000watts and from the PSU's ratings I see that, the 3 PSU's can provide max output of 6000 Watts, and the PDU's to which this enclosure was connected has capacity to provide the power.

Am I missing something in the settings ?