BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Is port remapping possible on HP c7000?

mc21_hp
Advisor

Is port remapping possible on HP c7000?

I have c7000 BladeSystem platform and BL460c G8 servers with HP FlexFabric 10Gb 2-port 554FLB Adapter. I have no mezz-cards. Cisco Catalysts are in the Interconnect Bays 1 and 2, Virtual Connect Flex Fabrics are in the Interconnect Bays 7 and 8.

Servers mapped to Bay1 and Bay2 (Cisco Catalysts) only:


SHOW SERVER PORT MAP 9

              Mezz
Mezz   Mezz  Device  Port      Interconnect Interconnect
Slot  Device  Port  Status         Bay        Bay Port       Device ID
----  ------ ------ ---------- ------------ ------------ ----------------

------------------------------- Blade 009 -------------------------------

    1 Not Present

    2 Not Present

 FLB1 HP FlexFabric 10Gb 2-port 554FLB Adapter
            Port 1 OK            Bay 1        Port 9     D8:9D:67:6B:15:48
            Port 2 OK            Bay 2        Port 9     D8:9D:67:6B:15:4C


How can I remap Port 2 of 554FLB Adapter to Bay 8 Port 9?

I didn't find any information about it.

Is it possible on c7000?

 

2 REPLIES
Torsten.
Acclaimed Contributor

Re: Is port remapping possible on HP c7000?

The connections between the server LOM and mezzanine cards and the interconnect bays are hard wired.

The C7000 User manual, the C7000 quickspec and other documents are showing you how.

 This is a full height blade:

127359

 

half hight blade

127358

 

 

So you need to kick out the ciscos or install a mezzanine card in slot 1, the VC modules in bay 3 and 4.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
peyrache
Respected Contributor

Re: Is port remapping possible on HP c7000?

hello

do you want to achieve this is correct configuration

554FLB is correctly mapped to port 9 (depending on chassis slot) on each interconnect in bay 1 and 2

JY