HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Issue with a Blade 460c

 
Pedr_1
Advisor

Issue with a Blade 460c

Hello everybody

I have an Enclosure 7000c with all bays full. One of blades, it shows me as degraded, at IML Log this appears:
Server Blade Enclosure Inadequate Power To Power (Enclosure Address 0000, Slot 2)

And some messages like this:
CPU(s) operating at reduced performance level due to an enclosure power event.


Power System is well, it doesn't report me anything.


Can somebody tell me how can I resolve this problem???

Thanks.
9 REPLIES
gregersenj
Honored Contributor

Re: Issue with a Blade 460c

Check the reportet power consumption, on the other servers.

Especially if you got servers with PMC ver 3.3, It's got a known issue, with the power usage reporting.
If it report a high usage, you can't power more servers on.

BR
/jag
patrick haynes
Frequent Advisor

Re: Issue with a Blade 460c

there was also a recall on c-class power supplies, might want to double chk that too
patrick haynes
Frequent Advisor

Re: Issue with a Blade 460c

firmware?
Bhavin-Desai
Advisor

Re: Issue with a Blade 460c

Do you see any errors in OA syslog with respect to this blade server Bay.

Is it Vmware ESX installed blade?
Pedr_1
Advisor

Re: Issue with a Blade 460c

Hello again

This is OA firmware: 2.51 May 28 2009.

In others blades I see this warning:

CPU(s) operating at reduced performance due to an enclosure power event.

But they are working well....
The Brit
Honored Contributor

Re: Issue with a Blade 460c

Probably a stupid question, but,

Do you have a full compliment of 6 power supplies?

Is dynamic power mode enabled, or not??

Have you set a "Static Power Limit"?

Dave.
Pedr_1
Advisor

Re: Issue with a Blade 460c

Hi Brit

I have 6 power supplies.

Dynamic power mode is enabled.

and Static Power Limit is doesn't set, it empty.

patrick haynes
Frequent Advisor

Re: Issue with a Blade 460c

upgrade the firmware of the oa's and the ilo's at the very least!
Pedr_1
Advisor

Re: Issue with a Blade 460c

Ok thanks at all