HPE Community
BladeSystem - General
1753783 Members
7300 Online
108799 Solutions
New Discussion юеВ

Re: Memory issue BL280c - DDR3 10600R

 
Kjetil Valhovd_1
Occasional Advisor

тАО10-23-2009 09:04 AM

тАО10-23-2009 09:04 AM

Memory issue BL280c - DDR3 10600R

I have a problem with mith my DDR-3 memory.
Its a DDR-3 PC3 10600R 1333, who runs at 1066.

Installed in a HP Bl280c G6-server which is brand new.
Is there a way to change the FSB-Mem ratio on server BIOS ? Or any other solution to what causes the problem.

Please advise anyone :-)

Thanks!
0 Kudos
Reply
2 REPLIES 2
Viveki
Trusted Contributor

тАО10-23-2009 09:35 AM

тАО10-23-2009 09:35 AM

Re: Memory issue BL280c - DDR3 10600R

Hi,

The speed 1333 is supported setting in ROM based setup utility (RBSU).

Please refer page 20-21 in the below documnet:
http://h18004.www1.hp.com/products/quickspecs/13294_na/13294_na.pdf
0 Kudos
Reply
Kjetil Valhovd_1
Occasional Advisor

тАО10-23-2009 09:42 AM

тАО10-23-2009 09:42 AM

Re: Memory issue BL280c - DDR3 10600R

Thanks a lot.
I will dig into this on monday.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.