HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Mezz card Interconnect connectivity

 
mohan lal_1
Occasional Visitor

Mezz card Interconnect connectivity

I want to do external loop back test of mezzanine card on a c class blade. My blade onboard administrator shows that Mezzanine card M1 is connected to Int 3. The interconnect is a GbE2c with 5 ports. TO put the mezzanine card in loopback do i need to connect external loopback plugs to all ports of the Gbe2C or any specific one.
1 REPLY
HEM_2
Honored Contributor

Re: Mezz card Interconnect connectivity

putting loopback plugs on the external ports of the GBE2c will not be the same thing as putting a loopback plug on a NIC. There is not a way to do that physically with the GBE2c's installed in a c-Class enclosure.

If you are just trying to run diagnostics from the Network Configuration Utility, the Loopback test should work without loopback plugs.