HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Mixing VC-ENet Copper & Fiber Modules

 
sgunelius
Valued Contributor

Mixing VC-ENet Copper & Fiber Modules

Does anyone know if I could mix a VC-ENet Copper and VC-ENet Fiber module in the same c7000 chassis? Would I only be able to configure these for active/passive failover or could we do active/active failover? Thank you in advance for your response.

Regards,

Scott
1 REPLY
HEM_2
Honored Contributor

Re: Mixing VC-ENet Copper & Fiber Modules

you can mix them no problem and you can use them in an active/active configuration scenario.