BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Onboard administrator

Veronique Canon
Occasional Visitor

Onboard administrator

Hi,

I have a C700 enclosure with two OA
the master respond to ping, but the slave is not responding

It is normal ?
firmware is 2.41

thanks
4 REPLIES
c3_1
Advisor

Re: Onboard administrator

No, both of my 2.41 OAs respond to pings.
Adrian Clint
Honored Contributor

Re: Onboard administrator

Do you have enclosure IP mode set on?

Go into your OA.
Enclosure Information/Enclosure settings/Enclosure TCP/IP settings.

Do both OAs have IP settings?

Try turning off enclosure IP mode. Giving both OA's settings. Verify you can ping both and then turning enclosure IP mode back on.
JL123
Frequent Advisor

Re: Onboard administrator

Hi there.

I have the same problem. It was working fine, but then due to a new naming convention change I had to change the name of our OA's, and during the name change the active was fine, but the standby has gone offline and says 'initialising' even after setting the IP details on the LCD display.

Firmware 2.41 also, I might upgrade to 2.51 and see how we go.
JL123
Frequent Advisor

Re: Onboard administrator

Just to let everyone know that upgrading to the 2.51 firmware has fixed the issue.