BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

P-Class GBe2 Blades

Alan Strange
Occasional Visitor

P-Class GBe2 Blades

Hi,
New to this forum and just wondering two things :-
- how do you break in and do a password recovery on the p-class blade switch.
- can you reset the blade switch back to factory defaults?

Thanks.

Alan.
3 REPLIES
Raghuarch
Honored Contributor

Re: P-Class GBe2 Blades

Hi Alan,

Call HP technical support or your service representative to get a backdoor password.
refer to page 60 of the below doc.
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00291270/c00291270.pdf

Regards,
Raghuarch
RDMOODY
Occasional Advisor

Re: P-Class GBe2 Blades

If you'll throw sw1 on the large DIP it will disable the ILo password.

If you throw sw6 and boot to the splash screen and shut down it will reset to factory defaults...
Víctor Cespón
Honored Contributor

Re: P-Class GBe2 Blades

He's asking about the GbE2 network switch password. He must connect to the serial port on the switch and provide the password that only HP technical supports know.