BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

P-Class Loss of chassis connectivity

 
SOLVED
Go to solution
Koopa
Frequent Advisor

P-Class Loss of chassis connectivity

We have several racks which appear to be showing the same fault on the IML where we get this loss of chassis connectivity and then either in the same minute or a minute later it then says it's connected again. The issue i'm currently looking at shows it's one of either of the 3 phase power enclosures we have. I read another post where someone had an issue like this, and it ended up being the way their power was wired up. Is there a way I can check if it's the way it's been wired up? If it was the wiring, would this issue only occur every couple of weeks?
2 REPLIES
Blazhev_1
Honored Contributor
Solution

Re: P-Class Loss of chassis connectivity

hi,

this was a false error and a bug in older Fws of the management module

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c01122571&jumpid=reg_R1002_USEN

update the module to 2.40
Koopa
Frequent Advisor

Re: P-Class Loss of chassis connectivity

Blazhev, thanks for the quick reply, your a star