cancel
Showing results for 
Search instead for 
Did you mean: 

Pass-Thru Module

Adithya
Occasional Contributor

Pass-Thru Module

I can't have IP & could not Connect to external switch in HP WS460c G6 by Using Pass-Thru Module in c3000...

Please Advice...

5 REPLIES
TTr
Honored Contributor

Re: Pass-Thru Module

Are you using the correct port on the passthrough module? The port on the passthrough module needs to match the slot of the blade.
Matti_Kurkela
Honored Contributor

Re: Pass-Thru Module

Does the external switch support gigabit speeds? The Pass-Thru Module is gigabit *only*: it is not 1000/100/10 like most ordinary NICs.

MK
MK
JKytsi
Honored Contributor

Re: Pass-Thru Module

check also workstation side, use autoneg. for network speed.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
Adithya
Occasional Contributor

Re: Pass-Thru Module

I use Port 1 for Balde in Bay 1.
Can u tell me how to use Autoneg???
I dont have experience in WorkStation:-(
So Many Thanks...
Johan Guldmyr
Honored Contributor

Re: Pass-Thru Module

Hi,

autoneg means a setting for the network card to autonegotiate inside the operating system on the workstation blade.

Do you have an on board administrator for this enclosure? Maybe there's some settings that needs to be set..

Do you get link? Are any other blades working?