HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Power Phase sequence question.

 
chuckk281
Trusted Contributor

Power Phase sequence question.

Christian had a customer UPS question and power sequencing:

 

*********

 

My customer has about 20, C7000 BladeSystem  Enclosures in his datacenter, each connected to one big UPS.

 

He use at all enclosures the three phase AC configuration (400 V) with dynamic power savings mode and noticed, that the third power phase is nearly not used at every enclosure.

This circumstance cause a negative impact for the effectiveness of his UPS-system.

 

Is it possible to configure a sequence for the power phases, to distribute the power consumption between them ?

 

*************

 

Input from Scott:

 

*************

 

This is normally a manual procedure in the infrastructure. It can be done with PDU’s;

 

webpic262.jpg

 

*************

 

Other comments or suggestions?