Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Power Supply Malfunction

nbu
Occasional Visitor

Power Supply Malfunction

Hi,

I have the following problem: 

My C7000 enclosure has popup a critical alarm on Power Supply #6, I have replaced the supply with new supply and then the critical error of PS down has removed. However, after 24 hours I have noticed that PS #3 have pop up critical alarm of power fail.

Can you please tell me why? What is my problem? It is might be enclosure problem or maybe not calibrate supplies?

 

Please advise.

<script type="text/javascript" src="resource://fpi/injected_script.js"></script>
1 REPLY
Robert_Jewell
Honored Contributor

Re: Power Supply Malfunction

When the PS was replaced was it repalced with the same type?  Mixing of PS types is not supported, but I dont think it would cause a failure of another PS module.

 

How long have these been running?  I would bet you just had two PS failures in a short amount of time.

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!