BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Power supply mismatch in C7000

SantokhB
Frequent Advisor

Power supply mismatch in C7000

WE have a two enclosures one which has power supplies part number 588733-001 and we tried to move 2 power supplies from one enclosure to the other one and the OA is complaining that the power supplies have to be all the same part number. The part number on the 2nd enclosure power supplies is 500242-001. Is there a way round this?
3 REPLIES
Jan Soska
Honored Contributor

Re: Power supply mismatch in C7000

Hello, I am afraid it is new policy for power supplies after one of OA firmware release. It is due compatibilty issues between them. Isn't it posible to you have the same part in one blade chasis?

Jan
SantokhB
Frequent Advisor

Re: Power supply mismatch in C7000

Hello,

That is exactly waht we did in the end. All is well again.

Thanks
Ragie
Advisor

Re: Power supply mismatch in C7000

Hello,

 

Just to inform everybody.

Here is the link from HP about HP BladeSystem - Mixing Different Power Supplies in C7000 Enclosure - Not Supported.

 

click on this link

 

Hope it helps.