BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Power topology error in P class Blade enclosure

 
Navarathanavel
Occasional Visitor

Power topology error in P class Blade enclosure

Iam having P class Blade enclosures with Blade 20p & 25p. Iam getting error power topolgy mismatch.
2 REPLIES
Patrick Terlisten
Honored Contributor

Re: Power topology error in P class Blade enclosure

Hello,

where did you get this error? Are both power busses under voltage?? All power supplies up and running? Are you using single phase or three-phase?

Best regards,
Patrick
Best regards,
Patrick
Blazhev_1
Honored Contributor

Re: Power topology error in P class Blade enclosure

Hi,

update the firmware of the management modules :

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=327558&prodNameId=3288172&swEnvOID=1005&swLang=8&mode=2&taskId=135&swItem=MTX-e25b66dcc42a4b798fc4a7ddaa

If the error is not gone away, reset the management module, check for LEDs near the bus bars in back of the enclosures...

Have you configured any power zones?
Is this a false message or something is not functioning fine?

Pac