HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem with installation last three blades in C7000

 
marino crippa
Occasional Contributor

Problem with installation last three blades in C7000

I've a C7000 with 2 BL685 and 8 BL465. The customer has purchased 2 new BL465 and 1 BL685. When I install BL685 in slot7 i can't install the other BL465 because i have extract the double metal guide in slot 7 and 8. Is this configuration possible? If yes is there a new single metal guide to install the last Blades? Thanks in advance
marino.crippa@hp.com
3 REPLIES
Igor Karasik
Honored Contributor

Re: Problem with installation last three blades in C7000

Hi,
I have similar problem and I didn't find any solution (except in my case I am a customer ...)

http://forums12.itrc.hp.com/service/forums/questionanswer.do?threadId=1191317
Jeff Allen_5
Valued Contributor

Re: Problem with installation last three blades in C7000

Mixing FH and HH servers within the same power zone is not possible today. Don;t try to make it fit as you will bend the pins on the midplane and/or destory the connector on the blade as they will not line up. The only exception is if you have a Storage blade - in that case, the storage blade can be used on the bottom and the server blade on top.
Igor Karasik
Honored Contributor

Re: Problem with installation last three blades in C7000

>>Mixing FH and HH servers within the same power zone is not possible today.

Jeff, can you look into my question here ?
http://forums12.itrc.hp.com/service/forums/questionanswer.do?threadId=1191317

If I understand right your answer to Marino, in my case we need to remove server in buy 14 - so we will end with two unused buys ?