Community
BladeSystem - General

Remote connection to the blades via ProCurve 6120G/XG

 
SOLVED
Go to solution
Hai Scai
Occasional Contributor

‎06-12-2011 05:12 PM

‎06-12-2011 05:12 PM

Remote connection to the blades via ProCurve 6120G/XG

Hi,
I can't access the blades from my desktop and, as I am a novice, I would appreciate some help.
I thought that the default settings (DEFAULT VLAN, all ports, untagged) would allow me to connect to the blades as my desktop is on the same subnet. Ping works fine between the blades but not between my desktop and the blades.
Could anyone please make some suggestions?
Thank you!
Hai
0 Kudos
Reply
2 REPLIES 2
Patrick Terlisten
Honored Contributor

‎06-13-2011 05:37 AM

‎06-13-2011 05:37 AM

Solution

Re: Remote connection to the blades via ProCurve 6120G/XG

Hello,

are your switches uplinked to a core? Are there any blocked uplinks by spanning-tree?

Regards,
Patrick
Best regards,
Patrick
Reply
Hai Scai
Occasional Contributor

‎06-13-2011 05:52 AM

‎06-13-2011 05:52 AM

Re: Remote connection to the blades via ProCurve 6120G/XG

I turned off the spanning-tree and now everything is working fine.
Thanks for your suggestion! All the best!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.