HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Removed a nic Mezzanine on my 460c g6 blade and now system management gives me an alert

 
Snak3eye5
Frequent Advisor

Removed a nic Mezzanine on my 460c g6 blade and now system management gives me an alert

I Removed a nic Mezzanine card which gives me two extra nics out of my 460c g6 blade to another one in another chassis since the orginal blade did not need the two extra nics. Since i removed the mezanine card, I have a system management alert saying an ethernet link failure in bay 2. I just don't understand why its not refreshing itself and just seeing that its not there and that its ok.  I have allready tried to update firmware and psp and refreshed the system management page. It did not work. Any ideas on how i can get the alert message to go away.