HPE Community
BladeSystem - General
1753770 Members
4895 Online
108799 Solutions
New Discussion юеВ

Replacing a FC Module

 
Tuscani_1
Frequent Advisor

тАО06-13-2011 09:28 AM

тАО06-13-2011 09:28 AM

Replacing a FC Module

Hope this is not a silly question. :) I am replacing a 4GB FC module in a c7000 (bad port). I assume the swap is transparent since I have two? Will the WWNs or VC profiles be affected?

Thanks!
0 Kudos
Reply
2 REPLIES 2
The Brit
Honored Contributor

тАО06-13-2011 09:50 AM

тАО06-13-2011 09:50 AM

Re: Replacing a FC Module

No. The only thing that you might have a problem with is F/W levels. If your new module F/W is different to the existing modules, then you will start generating VC errors.
If you have an empty Interconnect bay on your enclosure, put your new module in there and use VCSU to set the F/W version the same as your current modules.

Dave
0 Kudos
Reply
Tuscani_1
Frequent Advisor

тАО06-13-2011 09:56 AM

тАО06-13-2011 09:56 AM

Re: Replacing a FC Module

Perfect.. thx Dave
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.