HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Replacing a failed Flex-10 module.

 
The Brit
Honored Contributor

Replacing a failed Flex-10 module.

I have a failed Flex-10 module in bay 2 of one of my c7000 enclosures.

I have not been able to find an "official" HP document giving the full procedure for replacement.

If anyone can point me to this documentation, I would really appreciate it. I have seen some comments indicating that the module must be removed from the domain (administratively), but this is an issue since this can only be done after removing all references to the failed module in every profile in the domain, a real pain in the butt.

However I have also seen comments indicating that the modules are fully hot-swappable and can basically be "just swapped".

I would really like to see the "official" version.

thanks

Dave.
3 REPLIES
David Claypool
Honored Contributor

Re: Replacing a failed Flex-10 module.

Page 55 of the "HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide"
The Brit
Honored Contributor

Re: Replacing a failed Flex-10 module.

Thanks for the info. I needed to download the latest version of the Guide.

The Brit
Honored Contributor

Re: Replacing a failed Flex-10 module.

see above